Olympus WS-760M Instructions Manual page 84

Symptom
Recording level too
low
Voice files are not
recorded in stereo
Cannot find the
recorded Voice File
Noise heard during
playback
Unable to erase the
7
file
Unable to erase the
folders
Noise is audible
through the recording
monitor
Unable to set index
marks, tempmarks
EN
84
Probable cause
The microphone sensitivity is too low.
This could potentially be because
the output level for the connected
external devices are too low.
The connected external microphone
is monaural.
[Rec Mode] is set to a monaural
recording mode.
[Zoom Mic] is set to the + side.
Wrong folder.
The recorder was shaken during
recording.
The recorder was placed near a cell
phone or fluorescent lamp while
recording or during playback.
The file is locked.
The file is read-only.
There is a file which cannot be
recognized by the recorder in the
folder.
Acoustic feedback is occurring.
The maximum number of marks has
been reached.
The file is locked.
The file is read-only.
Troubleshooting
Action
Set [Mic Sense] to [High] or [Middle]
(☞ P.47, P.49).
Adjust the output level for the
connected devices.
When recording while an external
monaural microphone is connected,
sound will only be recorded by the
L-channel.
Set [Rec Mode] to the stereo
recording mode (☞ P.47, P.49).
Set [Zoom Mic] to [Off] (☞ P.47, P.50).
Switch to the correct folder
(☞ P.22 to P.24).
———
Move the recorder.
Unlock the file (☞ P.47, P.49).
Unlock the file or cancel the read-only
setting of the file on the PC.
Connect the recorder to your PC and
erase a folder (☞ P.67, P.69).
When the built-in speaker amps and
the like are connected there is a risk
that audio feedback will occur while
recording. It is recommended that
you use earphones for the recording
monitor.
Conduct adjustments like separating
the earphones from the microphone
further, do not point the microphone
at the earphones, lower the volume on
the recording monitor, and so on.
Erase unnecessary marks (☞ P.35).
Unlock the file (☞ P.47, P.49).
Unlock the file or cancel the read-only
setting of the file on the PC.