Using The Remote Control; Precautions; Remote Control Keys - Sanyo DP42746 Owner's Manual

PRECAUTIONS

To ensure safe operation, please observe the follow-
ing precautions:
Use (2) AAA alkaline batteries, see page 8.
Replace both batteries at the same time. Do not use a
new battery with a used battery.

REMOTE CONTROL KEYS

Œ
nput Key—Press to change the input signal source
I
as follows: Analog RF ¬ Digital RF ¬ Video 1 ¬
Video 2 ¬ Video 3 ¬ HDMI ¬ Analog RF .

Number Key—Two keys must be pressed to select a
direct channel. Example: Press 0 then 6 to select
channel 6.
For Analog Cable channels above 100, press and
hold the 1 key until C1– – appears, then press the
other two numbers.
Ž
Info Key—Press to display the Digital and Analog Full
Banner information (press again to remove the
display).
Digital Full Banner display— Contains a two-part
Channel Number (Major and Minor) and Tuner ID. If
available the following is also included: Station ID,
Program Title, V-Guide Program Rating, Audio Info, and
Signal Strength.
Channel
Major Minor
Tuner ID
Program Title Audio Info
Analog Full Banner display— Contains the Channel
Number (analog antenna/cable), Tuner ID, Station ID (if
available), Program Title (if available), V-Chip Program
Rating, and Audio Info.
Tuner ID Channel No.
Program Title
Audio Info
16
Need help?
Visit our Web site at

USING THE REMOTE CONTROL

Station ID
Program Rating
Signal Strength
Program Rating
Station ID
www.sanyoctv.com
1-800-877-5032
or Call
Risk of explosion, if battery is replaced by an incorrect
type.
If batteries have leaked in the Remote Control Unit,
carefully wipe the case clean and load new batteries.
Do not expose the Remote Control Unit to moisture,
or heat.
Point toward
DTV
Œ

Ž


‘
’
“
”
•
11
12
13
14
15
16
17
18