Getting Started (Required Initial Setup); Installing Batteries In The Remote Control; Connect Signal (Digital / Analog); Connect Ac Power Cord - Sanyo Vizzon DP50747 Owner's Manual

Sanyo plasma hdtv owner's manual
Hide thumbs Also See for Vizzon DP50747:
Table of Contents

Advertisement

Available languages

Available languages

GETTING STARTED
1
Install batteries in remote
control (2AAA, not included).
PRECAUTIONS
To ensure safe operation, please observe
the following precautions:
R
eplace both batteries at the same time. Do
not use a new battery with a used battery.
Risk of explosion, if battery is replaced by
an incorrect type.
Do not expose the Remote Control Unit to
heat.
moisture or
2
Connect Signal to the DTV's Integrated
Analog / Digital 75 ohm Antenna Input
terminal.
RF ANTENNA
OR
CABLE
OR
CABLE BOX OR SATELLITE BOX
THE TUNER IN THIS PLASMA DTV CAN RECEIVE:
1. Digital and / or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note: You must search for ClearQAM channels using
the "Digital Cable Search" menu option.
OR
3. The output from a VCR or cable box.
Digital signals can also be received through the HDMI
jacks.
Signals from a Set-top (STB) Box should be received
through the Video 1, 2, or 3, or HDMI Input 1, 2, or 3
jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
(REQUIRED INITIAL SETUP)
Match the "+" and "–" signs
on the batteries with marks
inside the remote control.
ANALOG/
DIGITAL
ANTENNA IN
Need help?
3
Connect AC Power Cord (supplied) to the
Plasma DTV and electrical outlet as shown
here.
To POWER CORD
CONNECTOR on
back of Plasma DTV.
4
Press the POWER key. (Follow on-screen
instructions).
5
Perform "All Channel Search." The All Channel
Search will search for off-air digital and analog
channels, and analog cable channels. The DTV
can receive cable or off-air channels, but not at
the same time. If after two searches the DTV
INITIAL ON-SCREEN
ALL CHANNEL SEARCH
ANALOG CHANNELS
Note: If EXIT is pressed,
the DTV will skip Channel
Search and tune to Video1
without storing any chan-
nels in the Channel Map
database.
www.sanyoctv.com
Visit our Web site at
The AC outlet must be near
this equipment and must
be easily accessible.
To 120 V AC outlet.
still fails to detect any
channels, the DTV will
tune to Video1.
DIGITAL CHANNELS
«
1-800-877-5032
or Call
5

Advertisement

Table of Contents
loading

Table of Contents