Table of Contents
Advertisement
Basic Operations
Performing the system check
3-1. Touch the [C] key to display the next menu
screen.
3-2. Touch the []] key of the SYSTEM CHECK
item.
The available operation mode is listed in
white letters.
3-3. Touch [Check] key at the top right of the
screen to perform the system check
manually.
The system will be restarted after
performing the system check.
Selecting the PTY display language
See the section entitled "Switching the PTY
display language" (page 38).
Linking AF functions in the RDS and
DAB modes
See the section entitled "AF functions between
RDS and DAB" (page 35).
Setting the Auto Panel
When you remove or attach the DCP
(Detachable Control Panel), you can set the
liquid crystal panel automatically housing or
opening.
• The factory default setting is "OFF".
3-1. Touch the [C] key to display the next menu
screen.
3-2. Touch the [ON], [OFF] or [CLOSE] key of
the AUTO PANEL item to set to "ON", "OFF"
or "CLOSE".
ON :
The liquid crystal panel houses
automatically after removing the DCP.
And the liquid crystal panel opens
automatically after attaching the DCP.
OFF :
Normal operation.
CLOSE :
The liquid crystal panel houses
automatically after removing the DCP.
30
Setting the time of air conditioner
operation mode
This setting can be used to adjust the time the
panel stays in the horizontal position when in the
air conditioner operation mode.
• The factory default setting is 10 seconds.
3-1. Touch the [C] key to display the next menu
screen.
3-2. Touch the [5s], [10s] or [30s] key of the
HVAC MODE item to set the time to "5
seconds", "10 seconds" or "30 seconds".
Advertisement
Table of Contents
