4.
Pass the remote control cable through the supplied wire grommet
and fit the grommet into the maintenance cover knockout.
5.
Plug the remote control cable into the 6-pin connector.
6.
Install the maintenance cover and tighten the cover screw.
REMOTE
CONTROL CABLE
REMOTE CONTROL CABLE
REMOTE CONTROL BOX
7.
To avoid accidentally unplugging the remote control cable, secure
the cable to the generator frame with a cable tie as shown.
CABLE TIE
Never operate the generator
without the maintenance cover in
place, as poor engine and generator
performance will result.
When the remote control is not
being used, replace it with the plug
on the connector.
MAINTENANCE COVER
OPTIONAL PARTS
GROMMET
PLUG
91