Starting And Stopping - Briggs & Stratton Vanguard Diesel 432447 Operating & Maintenance Instructions

Typical starter switch
[4]. When GLOW light goes out,
turn key to START.
CAUTION:
DO NOT accelerate or race a
cold engine. Failure to ob-
serve this caution may lead
to engine damage.
TO STOP ENGINE
Typical throttle control
[1]. Move throttle to SLOW.
Allow engine to run for
short time to cool down.
CAUTION:
To prolong starter life,
use short starting cycles,
not to exceed 30 secs./
min.
Extended cranking can
damage starter motor.
[6]. Move throttle control to SLOW
(if in FAST for cold starting
instructions).
[7]. Allow engine to warm up a few
minutes before applying load.
Typical starter switch
[2]. Turn key to OFF.
Always remove key and
store out of reach of children.
11

STARTING AND STOPPING

Typical starter switch
[5]. When engine starts, release key,
which will return to ON position.
Typical throttle control
CAUTION:
FOR TURBOCHARGER-EQUIPPED
ENGINE.
After operating engine at full load, allow
engine to idle for one minute before shutting it
off. Failure to observe this caution may lead
to turbocharger malfunction.