Adjustments; Storage - Briggs & Stratton Vanguard Diesel 432447 Operating & Maintenance Instructions

LOCK NUT
IDLE
SPEED
SCREW
Ì Ì Ì Ì Ì Ì
Injector pump
CONTROL ADJUSTMENTS
If engine is hard to start or acceleration is uneven, check
control operation and adjust if required as described
below:

STORAGE

Engines stored over 30 days need special attention.
[1]. While engine is still warm, change oil.
[2]. Remove glow plugs and pour about 3 cc of engine oil into
each cylinder. Replace glow plugs and crank slowly to
distribute oil.
[3]. Clean engine of surface debris, chaff or grass.
See any Authorized Briggs &
Stratton Daihatsu Service Deal-
er. Insist on Genuine Briggs &
Stratton Daihatsu parts! Non-
original parts may not perform as
well and may void your warranty.
To obtain a complete Parts List
of Genuine Briggs & Stratton
Daihatsu Parts for your engine,
fill in both sides of this order form
carefully. We cannot fill your
order without the correct Engine
Model/Type/Code. (Please al-
low 3 to 4 weeks for delivery.)
SPEED
CONTROL
LEVER
Fill in both sides, clip and return to:
Briggs & Stratton Daihatsu Corporation
P.O. Box 1144
Milwaukee, WI 53201-1144 U.S.A.
Name
Address
City
Your Engine
Model Type
17
TO ADJUST THROTTLE CONTROL
[1]. Move equipment throttle control in SLOW or IDLE
position.
[2]. If lever does not contract idle speed screw, loosen
casing clamp screw.
[3]. Adjust casing clamp screw to allow speed control lever
to contact idle speed screw.
[4]. Tighten casing clamp screw.
TO ADJUST IDLE SPEED
[1]. Move equipment throttle control in SLOW or IDLE
position.
[2]. Loosen lock nut.
[3]. Adjust idle speed screw to obtain equipment manufac-
turer's specified idle speed.
[4]. Tighten lock nut.
[5]. Re-adjust throttle control if required.
[4].
WARNING
State Zip
Code

ADJUSTMENTS

STORAGE
Store in a clean, dry area. Do
not store in same area as a
stove, furnace, water heater, or
other appliance that uses a pilot
light or has a device that can
create a spark.
820853
Country