Water Pump Installation; O-Ring/Water Pipe Installation; Thermostat Installation; Water Temperature Gauge Unit Installation - Mitsubishi 4G1 series Workshop Manual

11A-6-4
4G1 ENGINE (E - W) -
E
Mitsubishi Motors Corporation
INSTALLATION SERVICE POINTS
"AA WATER PUMP INSTALLATION
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
"BA O-RING / WATER PIPE INSTALLATION
(1) Replace the water inlet pipe O-rings with new ones, then
"CA THERMOSTAT INSTALLATION
(1) Fit the thermostat such that its jiggle valve is at the top.
"DA WATER
(1) If the water temperature gauge unit is to be reused, apply
"EA WATER TEMPERATURE SENSOR INSTALLATION
(1) If the water temperature sensor is to be reused, apply
Nov. 1995
Water Pump and Water Hose
the mounting surface.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent.
apply water to the O-rings so that they can be inserted
easily into the water pump and thermostat case.
Caution
1. Do not apply engine oil or any other oily substance
to the O-rings.
2. Secure the water pipe after the thermostat case
has been installed.
TEMPERATURE
INSTALLATION
the specified sealant to its thread.
Specified sealant:
3M ATD Part No. 8660 or equivalent.
the specified sealant to its thread.
Specified sealant:
3M Nut Locking Part No. 4171 or equivalent.
PWEE9520
GAUGE UNIT