Reed Valve, Bracket And Air Pipe Installation - Mitsubishi 4G1 series Workshop Manual

11A-7-4
4G1 ENGINE (E - W) -
Reed valve and bracket
Pipe nut (reed valve side)
Air pipe
Reed valve
bracket "B"
Pipe nut (exhaust
manifold side)
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
INSTALLATION SERVICE POINTS
"AA REED VALVE, BRACKET AND AIR PIPE
(1) Insert the lower end of the air pipe into the exhaust
(2) Fit the upper end of the air pipe to the reed valve and
Pipe clamp bolt
(3) Attach the reed valve and bracket assembly to the reed
(4) Tighten the nuts on both ends of the air pipe to the specified
(5) Tighten the reed valve and bracket mounting bolts to
(6) Tighten the pipe clamp bolt.
Nov. 1995
July 1999
Intake and Exhaust Manifolds
INSTALLATION
manifold, then tighten the pipe nut temporarily.
bracket assembly, then tighten the pipe nut temporarily.
valve bracket "B" and tighten the mounting bolts
temporarily.
torque.
Caution
The tightening torque of the reed valve side nut and
that of the exhaust manifold side nut are different
from each other.
Be sure to tighten each nut correctly to the specified
torque.
the specified torque.
PWEE9520
PWEE9520-B Added