Weber Platinum I 2200 LP Owner's Manual page 12

Step 7
Add cooking box
You will need: frame assembly, cooking box assembly, 1/4-
20 x 2 inch bolt, 1/4 inch nylon washer, 1/4-20 keps nut,
spacer bracket, pliers and a 7/16 inch wrench.
Set the cooking box into the frame so the burner tubes are
under the frame brace. Figure 6.
Figure 6
Slide the cooking box to the left within the frame. Put the
washer on the bolt. Take the spacer bracket and hold it
up to the frame making sure both tabs fit underneath the
frame cross piece. Figure 7 (a). Insert the bolt through
the center hole in the spacer bracket, frame and cooking
box with the head of the bolt outside the spacer bracket.
Figure 7 (b). Add the keps nut. Figure 7. Tighten by holding
the bolt with pliers while you tighten the nut with a wrench.
Spacer bracket
Keps nut
(b)
Bolt
Nylon washer
Figure 7
Burner tubes
Frame brace
Frame cross piece
(a)
Your Weber Gas Barbecue burner assembly has been
factory assembled, pressure and flame tested. As a safety
precaution we recommend you check the burner alignment:
a) Do the valves fit into the ends of the burners?
Figure 8 (a).
b) Are the ends of the burners under the washers at the
left rear and left front of the cooking box? The screws
are only guides. Do not tighten. Figure 8 (b).
c) Are the wing nuts under the burner assembly hand
tight? Do not tighten with pliers. Figure 8 (c).
If you answered YES to a, b and c, the burners are correctly
aligned. If you answered NO, the burners are misaligned.
Contact your dealer. Do not use your barbecue.
Guide screw
(b)
Figure 8
12
(a)
(c)
Wing nuts