ZyXEL Communications P-660RU-T1 v3 User Manual page 102

Chapter 11 Quality of Service (QoS)
Table 27 Advanced Setup > QoS
LABEL
Summary
Rule
Rule Index
Active
Application
Physical Ports
Destination MAC Type a destination MAC address here. QoS is then applied to traffic containing this
IP
Mask
Port Range
Source MAC
IP
Mask
Port Range
Protocol ID
Vlan ID Range
IPP/DS Field
IP Precedence
Range
Type of Service
DSCP Range
802.1p
Action
IPP/DS Field
IP Precedence
Remarking
Type of Service
Remarking
102
DESCRIPTION
Click this to open a summary table showing the QoS settings. See
on page 103 for more details.
Select the rule's index number from the drop-down list box.
Use this field to enable or disable the rule.
Select an application from the drop-down list box. The Destination Port Range and
Protocol ID fields may change depending on the type of applications you choose.
Select Enet1 to apply the rule to the Ethernet port or select USB to apply the rule to
the USB port.
destination MAC address. Leave it blank to apply the rule to all MAC addresses.
Enter a destination IP address in dotted decimal notation. QoS is then applied to
traffic containing this destination IP address. A blank destination IP address means
any destination IP address.
Enter a destination subnet mask here.
Either use the default value set by the application you choose, or enter the port
number to which the rule should be applied.
Type a source MAC address here. QoS is then applied to traffic containing this
source MAC address. Leave it blank to apply the rule to all MAC addresses.
Enter a source IP address in dotted decimal notation. QoS is then applied to traffic
containing this source IP address. A blank source IP address means any source IP
address.
Enter a source subnet mask here.
Enter the port number to which the rule should be applied. 0 means any source port
number. See Appendix D on page 213
numbers.
Select an IP protocol type from the drop-down list box.
Enter the source VLAN ID in this field.
Select IPP/TOS to specify an IP precedence range and type of services.
Select DSCP to specify a DiffServ Code Point (DSCP) range.
Select a range from 0 to 7 for IP precedence. Zero is the lowest priority and seven is
the highest.
Select a type of service from the drop-down list box.
Available options are: Normal service, Minimize delay, Maximize throughput,
Maximize reliability and Minimize monetary cost.
Specify a DSCP number between 0 and 63 in this field.
Select a priority level (0 to 7) from the drop-down list box.
Select IPP/TOS to specify an IP precedence range and type of services.
Select DSCP to specify a DiffServ Code Point (DSCP) range.
Select from 0 to 7 to re-assign IP precedence to matched traffic. Zero is the lowest
priority and seven is the highest.
Select a type of service to re-assign the priority level to matched traffic.
Available options are: Normal service, Minimize delay, Maximize throughput,
Maximize reliability and Minimize monetary cost.
for some common services and port
P-660RU-Tx v3 User's Guide
Section 11.2.1