Table of Contents
Advertisement
RotoSphere™ LED QRG
AC Power
Power Linking
Fuse
Replacement
DMX Linking
DMX Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 20 RotoSphere™ LED units to this fixture at 120 VAC or
40 RotoSphere™ LED units at 230 VAC. Make sure to never exceed this
number.
1) Disconnect this fixture/product from the power outlet.
2) Wedge the tip of a flat head screwdriver into the slot of the fuse holder
and pry the safety cap out of its housing. It will pull the installed fuse
with it.
3) Remove the blown fuse from its safety cap and replace it with a fuse of
the exact same type and rating (F 1 A, 250 V).
4) Insert the fuse holder back in its place, and reconnect power.
The RotoSphere™ LED can work with a DMX controller when linked using
a regular DMX serial connection.
If you are not familiar with the DMX standard, please download the DMX
Primer document from www.chauvetlighting.com.
The RotoSphere™ LED uses a regular DMX data connection for its 4-
channel DMX personality.
Download the RotoSphere™ LED user manual and refer to the Setup
chapter to learn how to connect this fixture for DMX operation, and the
Operation Instructions chapter to learn in detail how to configure this fixture
for DMX operation.
The RotoSphere™ LED uses the DMX data connection for its Master/Slave
mode.
Download the RotoSphere™ LED user manual and refer to the Setup
chapter to learn how to connect this fixture for Master/Slave operation, and
the Operation chapter to learn in detail how to configure this fixture for
Master/Slave operation.
Page 4 of 8
Advertisement
Table of Contents
