Glass Cleaning - Dimplex DFB8842 Owner's Manual

Maintenance
Purifire™ Filter
The Purifire™ filter supplied in
your fireplace is reusable and
washable. The filter should be
cleaned or replaced on average
once a year. To clean the filter
gently tap filter on a hard sur-
face to dislodge any loose dirt or
debris, and then clean with water.
No soap or cleaning products are
recommended. The filter size
is 20 x 10 x 1 inches, rated at
MERV 10.
To replace filter:
1. Remove fireplace from mantel.
2. Filter can be accessed from
the top rear of the unit (Figure
9).
3. Grasp filter and slide filter
straight up.
4. Replace or clean filter.
!
NOTE: If after market air filter
is used ensure it is installed
according to the manufac-
turer's recommended instruc-
tions.

Glass Cleaning

The glass is cleaned in the factory
during the assembly operation.
During shipment, installation,
handling, etc., the clear door may
collect dust particles, these can
Figure 9
Purifire™
Filter
be removed by dusting lightly with
a clean dry cloth.
To remove fingerprints or other
marks, the clear door can be
cleaned with a damp cloth. The
clear door should be completely
dried with a lint free cloth to
prevent water spots. To prevent
scratching, do not use abrasive
cleaners or spray liquids on the
clear door surface.
Fireplace Surface Clean-
ing
Use damp warm cloth only to
clean painted surfaces. Do not
use abrasive cleaners on glass
surface or spray liquids directly
onto any surface.
17