Dimplex BLF74 Owner's Manual page 17

Operation
fireplace levels sequentially (from
off): flames only; to flames and
heat.
!
NOTE: There is a third level
that does not change the output,
before cycling back to flame only.
The level is increased every time
the ON button is pressed on the
remote control and the fireplace
can be turned off at any point by
pressing the OFF button.
Remote Control Initialization/
Reprogramming
If the remote control or remote
control receiver has been re-
placed, follow these steps to
initialize the remote control and
receiver:
1. Ensure that power is supplied
through the main service
panel.
2. Turn On/Off Switch to ON
(Figure 12A).
3. Move the 3-position switch
to the " REMOTE " position
(Figure 12B).
4. Press and hold the Manual
Control Button marked
for five seconds. After five
seconds, there is a 10 second
window to press any button
on the remote
" I "
control.
5. Press any button on the
remote control within that 10
seconds. This will synchro-
nize the remote control and
receiver.
Battery Replacement
To replace the battery:
1. Slide battery cover open on
the remote control (Figure
13).
2. Install one 12-Volt (A23) bat-
tery in the battery holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
Figure 13
On
Button
Off
Button
Plastic
strip
Battery
Cover
17