Audyssey Dsx; Lfe Level - Integra DTR-70.2 Instruction Manual

■
Volume Leveler
Off:
Volume Leveler off.
Low:
Low Compression Mode becomes active.
Mid:
Medium Compression Mode becomes active.
High:
High Compression Mode becomes active. This set-
ting affects volume the most, causing all sounds to
be of equal loudness.
"Volume Leveler" maintains the perceived loudness of all
content for example, from different channels or input
sources.
Note
• If the "Dolby Volume" setting is set to "Off", this setting cannot
be selected.
■
Half Mode
Off:
Half Mode off.
On:
Half Mode on.
The Half Mode parameter turns Dolby Volume Half Mode
processing ON and OFF.
In OFF mode, Dolby Volume applies a bass and treble
attenuation to the audio when the system gain exceeds ref-
erence level. This enables a more perceptually flat listen-
ing experience as human ears are more sensitive to bass
and treble at higher levels. Some listeners however, prefer
to have more bass and treble performance at higher gain
levels.
Note
• If the "Dolby Volume" setting is set to "Off", this setting cannot
be selected.
• During Half Mode ON playback, Dolby Volume does not apply
a bass and treble attenuation when the system volume exceeds
reference level thereby boosting perception of high and low fre-
quencies.
DTS
■
Neo:6 Music
Center Image
0 to 2 to 5
The DTS Neo:6 Music listening mode creates 6-channel
surround sound from 2-channel stereo sources. With
this setting, you can specify by how much the front left
and right channel output is attenuated in order to create
the center channel.
Setting a value "0" in the middle is set to hear a sound.
Sound is spread in left and right (the outside) so that the
set value is made big. Please adjust by liking.

Audyssey DSX™

■
Soundstage
–3dB to Reference to +3dB
With this setting, you can adjust the soundstage when using
Audyssey DSX™.
Note
• If the "Center" setting is set to "None", or both "Front High"
and "Front Wide" settings are set to "None"
cannot be selected.
Theater-Dimensional
■
Listening Angle
Wide:
Select if the listening angle is greater than 30
degrees.
Narrow:
Select if the listening angle is less than 30 degrees.
With this setting, you can optimize the Theater-Dimen-
sional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should
be equidistant from the listening position and at an
angle close to one of the two available settings.
Front left speaker

LFE Level

■
Dolby Digital *1 , DTS *2
TrueHD, DTS-HD Master Audio, DSD
– dB, –20dB, –10dB, or 0dB
With these settings, you can set the level of the LFE (Low
Frequency Effects) channel individually for each input
sources.
If you find that low-frequency effects are too loud when
using one of these sources, change the setting to "–20dB"
or "– dB".
*1 Dolby Digital and Dolby Digital Plus sources.
*2
DTS and DTS-HD High Resolution Audio sources.
*3 DSD (Super Audio CD) sources.
(➔ 55), this setting
Front right speaker
Listening angle: 30°
, Multich PCM, Dolby
*3
En
59