Controlling Ipod - Integra DTR-20.1 Instruction Manual

DTR-20.1_En_A.book Page 51 Wednesday, April 8, 2009 10:06 PM
UP-A1 series Dock for iPod—Continued
Operating Notes:
• Before selecting a different input source, stop iPod
playback to prevent the AV receiver from selecting the
iPod input source by mistake.
• If any accessories are connected to your iPod, the AV
receiver may not be able to select the input source
properly.
• While your iPod is in the UP-A1 series Dock, its
volume control has no effect. If you adjust your iPod
models volume control while it's in the UP-A1 series
Dock, make sure it's not set too high before you
reconnect your headphones.
■ Using Your iPod models Alarm Clock
You can use your iPod models Alarm Clock function to
automatically turn on your iPod and the AV receiver at a
specified time. The AV receiver's input source will
automatically be set to the [Port] selector.
Notes:
• To use this function, your iPod must be in the UP-A1
series Dock, and the UP-A1 series Dock must be
connected to the AV receiver.
• When you use this function, be sure to set the AV
receiver's volume control to a suitable level.
• The AV receiver may take several seconds to startup,
so you might not hear the first few seconds of the first
song.
■ Charging Your iPod models Battery
The UP-A1 series Dock charges your iPod models
battery while your iPod is in the UP-A1 series Dock and
connected to the UNIVERSAL PORT jacks on the AV
receiver. While your iPod is seated in the UP-A1 series
Dock, its battery will be charged when the AV receiver is
set to "On" or "Standby".
Note:
When UP-A1 series Dock that seated iPod is connected,
the power consumption on standby mode slightly
increases.

Controlling iPod

By pressing the Remote Mode button that's been pro-
grammed with the remote control code for your Dock,
you can control your iPod in the Dock with the following
buttons.
The [Port] button is preprogrammed with the remote
control code for controlling a Dock with Universal Port
connector.
For details on entering a remote control code,
see page 80.
When Using a Dock with Universal Port connector:
• Connect the Dock to the UNIVERSAL PORT jack.
• See to the Dock's instruction manual for more infor-
mation.
You can control your iPod when "Port" is selected as the
input source.
Press [Port] button first
Note:
For detailed operation of the iPod, please refer to the
instruction manual.
51