Up-A1 Series Dock For Ipod; About The Up-A1 Series Dock; Compatible Ipod Models; Putting Your Ipod In The Dock - Integra DTR-20.1 Instruction Manual

DTR-20.1_En_A.book Page 50 Wednesday, April 8, 2009 10:06 PM

UP-A1 series Dock for iPod

About the UP-A1 series Dock

With the UP-A1 series Dock (sold separately), you can
easily play the music, photo, or movie stored on your
Apple iPod through the AV receiver and enjoy great
sound. You can use the AV receiver's remote controller
to operate your iPod.
For the latest information on the Dock, see the Onkyo
Web site at: www.onkyo.com
iPod adapter
Dock connector

Compatible iPod models

For information about which iPod models are
supported by the UP-A1 series Dock, see the UP-A1
series Dock's instruction manual.
Note:
Before using the UP-A1 series Dock, update your iPod
with the latest software, available from the Apple Web
site at: www.apple.com

Putting Your iPod in the Dock

1. Turn on the AV receiver, and select the [Port]
selector.
2. Align your iPod with the Dock connector, and
carefully place your iPod in the slot, as shown.
Remove iPod
case before
inserting
50
iPod slot
■ Adjusting the iPod Adapter
The iPod adapter needs to be adjusted to match your
particular iPod. If there's a gap between the back of your
iPod and the adapter, turn the adapter counterclockwise
to close the gap. Turning the adapter counterclockwise
moves it forward. Turning it clockwise moves it
backward.
Forward
Notes:
• Make sure that the output level of the AV receiver is
set to minimum.
• To prevent iPod connector damage, don't twist your
iPod when inserting or removing it, and be careful not
to knock over the Dock while your iPod is inserted.
• Do not take off your iPod from the Dock when you
play back the music, photo, or movie stored on your
iPod.
• Don't use the Dock with any other iPod accessories,
such as FM transmitters and microphones, as they
may cause a malfunction.
• It is recommended that you update your iPod software
before using it with this unit. The updater for the iPod
software is available at the Apple website.

Function Overview

■ Basic Operation
Note:
The AV receiver may take several seconds to startup, so
you might not hear the first few seconds of the first song.
• Auto Power On Function
If you start iPod playback while the AV receiver is
on Standby, the AV receiver will automatically turn
on and select your iPod as the input source. Then,
your iPod will start playback.
• Direct Change Function
If you start iPod playback while listening to another
input source, the AV receiver will automatically
select your iPod as the input source.
• Using the AV receiver's Remote Controller
You can use the AV receiver's remote controller to
control basic iPod functions.
Backward