Maintenance - Montigo EP28-5 Installation & Operation Manual

Pilot Burner Adjustment
1. Determine which pilot is installed in the fireplace based on figure
25.
2. Locate Pilot Adjustment Screw. (See figures 24a , 24b, or 24c)
3. Adjust pilot key to provide properly sized flame. (See figure 24a,
24b, or 24c).
4. Replace pilot adjustment cap.
5. After installing or servicing, leak test with a soap solution with
main burner on. Coat pipe and tubing joints, gasket etc. with soap
solution. Bubbles indicate leaks. Tighten any areas where the
Figure 25. PSE Pilot Burner used on the EP28 Series models.
Troubleshooting
The following is a troubleshooting chart of possible problems:
PRoBLEM
Noisy Pilot Flame Remove pilot adjuster cap, located
on the gas control valve. Flame is de-
creased by turning adjustment screw
clockwise.
Pilot won't ignite Disconnect remote wires and try to
light pilot. If pilot now works, remote
connections are faulty. Check wiring
diagram
1. Check wiring (see figure 24a/b/c)
Main burner will
not light 2. Check wall switch for proper con-
nection.
XG0302C

Maintenance

EP28-5
CoRRECtIVE ACtIoN
24a/b/c.
figure
EP8-5 Modular Series Fireplace
Troubleshooting
If your fireplace still does not operate correctly, consult your dealer or
the manufacturer.
All service and repairs should be performed by a qualified
agency.
All spare parts, optional fans (see optional fan instruction guide), and
optional trim finishes are available from the manufacturer or your local
dealer.
EP28-5-I
Page 15