Removing And Installing The Door - Montigo L52DF-ST Installation, Operation & Maintenance Manual

f i r e f e a t u r e
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
Figure 28d.
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
Figure 28e.
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 28f.
Step 8:
Removing the Door:
Grasp the Door on either side, usually midway and lift upward, lift
the door carefully up and away from the front of the fireplace. See
figures 28g. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
Figure 28g. Removing and installing the glass doors. (Both Sides
Typical)
Installing the Door:
To install the door, hook the top edge of the door frame into place. Lower
the door into position and follow the previous steps shown in reverse order.
Part No. XG0711
Installation
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etching
may cause premature glass failure.
Do not operate this fireplace without the glass door, or with a
2
broken glass door.
Installing the Glass Beads and
L52DF-ST
Beads
The L52DF-ST is supplied with three bags of Designer Glass beads.
Place them randomly across the pan, surrounding the burners as
shown in Figure 27c.
3
Optional River Rocks
The L52DF-ST has optional cultured rocks which mimic real stone,
yet designed to withstand a high temperature environments. These
may be spaced at random, or in a visual patter of your preference.
Ensure the rocks or beads do not cover the Burners.
4
Figure 27c. Installation with glass beads .
L52DF(O)-ST See-thru Gas Fireplace
WARNING!
Optional Rocks
L42DF-ST
Page 11