Power Vent Installation (Selected Models); Wiring; Wiring For The Gas Control / Pilot - Montigo L52DF-ST Installation, Operation & Maintenance Manual

L52DF(O)-ST See-thru Gas Fireplace

Wiring

Gas Control and Pilot Wiring
Honeywell (Q3450)
Pilot Assembly
Gas Control
Connector
Fan Plug
Receptacle
Gnd Screw
Wall Switch
Figure 26.
Wiring for the L52DF-ST-I with Honeywell gas control and pilot.
Page 10
Installation
L52DF-ST-I
Pilot Electrical
Harness Connector
Honeywell Gas
Control (SV9501M)
Junction Box
115VAC
24VAC
40 VA
Transformer
Removing and Installing
L52DF-ST
Removing the doors:
The doors are removed in a few simple steps. Follow these Steps below
to remove the Horizontal access panel, unlatch the door buckles and,
remove the door. Replace in reverse order.
Step 1: Remove the Horizontal Access Pan-
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushng away from
you and lifting out. Place it
aside during maintenance or
cleaning.
Black
White Install in reverse order.
Green
Figure 28. Removing and installing the the Horizontal Acess Panel
Locate the Door Buckles:
Step 2:
Figure 28a. Loccate the door buckles. (Both Sides Typical)
Release the Door Buckles
Step 3:
Hand-hold
Figure 28b. Door buckle Tool
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 28c.
f i r e f e a t u r e
the Doors
Finger Holes
Installed Gas
Valve Cove r
Door Latch Hook
1
Door Latch Slot
Part No. XG0711