PERIODIC MAINTENANCE AND MINOR REPAIR
NOTE:
The engine oil should be between the
minimum and maximum level marks.
ZAUM0701
1. Engine oil filler cap
6
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil (with or
without oil filter element replace-
ment)
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and the engine oil drain bolt to
drain the oil from the crankcase.
1
ZAUM0702
1. Engine oil drain bolt
4. Check the drain bolt washer for
damage and replace it if neces-
sary.
ZAUM0129
1. Engine oil drain bolt
2. Washer
NOTE:
1
Skip steps 5–9 if the oil filter element is
not being replaced.
5. Remove the oil filter element cover
ZAUM0711
1. Oil filter element cover
6-8
1
by removing the bolts.
2
1