Lenovo ThinkServer TS440 User Manual page 47

Note: The number on the label for each of the four SATA signal cables indicates the sequence to follow
when you are connecting the cables to the corresponding SATA connectors (0-3) on the system board.
SATA signal cable label
For information about configuring RAID using the configuration utility for the ThinkServer RAID 100, see
"Configuring the system BIOS to enable onboard SATA RAID functionality" on page 57.
Refer to the following topics for information about the connector locations:
• "Hot-swap hard disk drive backplane" on page 30
• "System board components" on page 37
Connecting the mini-SAS signal cables from the RAID card to the backplanes for
server models with hot-swap hard disk drives
If your server has a supported RAID card installed, you can connect the mini-SAS signal cables from the
RAID card to the backplanes to support up to eight hard disk drives. In this case, you can configure RAID for
the hard disk drives using the advanced hardware RAID functions.
Note: The option package for the RAID card is designed for different types of servers and might contain
additional cables that are not required for installation.
P0
P1
P2
P3
System board SATA connector
SATA connector 0
SATA connector 1
SATA connector 2
SATA connector 3
.
Chapter 3 Product overview
35