Lenovo ThinkServer TS440 User Manual page 131

• For the 3.5-inch hot-swap hard disk drive cage, install the four screws to secure the backplane on
the cage.
Figure 72. Installing the backplane for server models with 3.5-inch hard disk drive bays
• For the 2.5-inch hot-swap hard disk drive cage, install the six screws to secure the backplane on
the cage.
Figure 73. Installing the backplane for server models with 2.5-inch hard disk drive bays
Note: If you want to install the following backplane for server models with 2.5-inch hard disk drive
bays, ensure that the backplane is secured by the two tabs
secure the backplane on the cage.
Figure 74. Installing the backplane for server models with 2.5-inch hard disk drive bays
1 . Then, install the three screws to
.
Chapter 6 Installing, removing, or replacing hardware
119