Cook's essentials CEPC800 Owner's Manual page 8

Control Panel Options
Once pressure is reached, the unit will begin to count down in minutes
and will beep 3 times when the cooking time has elapsed. Let the
pressure drop on its own by using the Natural Release Feature, or
release pressure immediately by pressing the Quick Steam Release
Button in short bursts until pressure is reduced. DO NOT hold this
button down, as hot liquids may be ejected. To cancel or stop cooking
before time has elapsed, press and hold the START/STOP Button
until the Red Light illuminates and the Pressure Cooker beeps.
4. COOK TIME: Use this Timer when using the COOK MODE (STEAM)
Function or the PRESSURE MODE (HIGH or LOW) settings. Press
COOK TIME Button to set the desired cooking time, up to 99 min-
utes.
5. DELAY TIME: Allows you to begin cooking food up to two hours
later in 1/2 hour increments.
6. START/STOP: After choosing the desired function: WARM, COOK
MODE: (BROWN or STEAM), or PRESSURE MODE: (HIGH or LOW),
and if appropriate, a COOK TIME, press the START/STOP Button to
begin operating the appliance. The Green Indicator Light will be lit
when START is chosen. The Red Indicator Light will illuminate for
STOP. If you wish to change your selection, or to stop the appliance,
press and hold START/STOP until the Red Indicator Light illuminates
and the Pressure Cooker beeps.
This Pressure Cooker has an idle mode. If you input a COOK TIME
and/or DELAY TIME, but forget to select a program or if you forget to
press START, the clock will display "--" after 5 seconds. This feature is for
your convenience to show that the program is incomplete. The "--" signal
indicates that the Pressure Cooker is not programmed properly and will
not run. You can proceed with the program where you left off by pressing
the COOK TIME or DELAY TIME Button. Your selected time will reap-
pear. If this time does not appear, or if it is incorrect, simply enter the cor-
rect time and then press the START/STOP Button.
8
(Cont.)