WASHER CONNECTIONS FOR STATIONARY MODELS
WSLS1100 AND WSLM1100
WARNING:
FLUSH WATER LINES
1
Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog up
the water valve screens.
2
CONNECT TO WATER LINES
Connect the inlet hose ends to the HOT and COLD
water faucets tightly by hand, then tighten another
turn with pliers. Turn the water on and check for leaks.
CAREFULLY MOVE THE WASHER
3
TO ITS FINAL LOCATION
Installation Instructions
Make sure the washer is unplugged.
⁄
2
3
CONNECT DRAIN HOSE
4
Form a U shape on the end of the drain hose with the
hose pointed toward the drain. Place the hose in a
laundry tub or stand pipe and secure it with a cable tie
(not included).
NOTE: If the drain hose is placed in a stand pipe
without forming a U shape, a siphoning action could
occur. There must be an air gap around the drain hose.
A snug hose fit can also cause a siphoning action.
Laundry Tub
Cable Tie
Stand Pipe
Cable Tie
Cable Tie
11