Portable Model Wslp1100; Washer Connections For - GE WSLM1100 Owner's Manual & Installation Instructions

WASHER CONNECTIONS FOR PORTABLE MODEL
WSLP1100 – ONE-FAUCET CONNECTIONS
Use the hose connector provided with the washer for a
one-faucet connection.
TO CONNECT THE WASHER:
1 REMOVE THE UNI-COUPLE
HOSE FROM INSIDE THE
WASHER BASKET
COLD Water
Supply Connector
Uni-Coupler Hose
CONNECT TO WATER LINE
2
Attach the hose connector to the faucet adapter by
pulling down on the locking collar while lifting up
on the connector until it snaps into place. Make sure
the water filter provided is in place.
Hose Connector
Installation Instructions
®
Drain Connection
Faucet Connector
Water Filter
Locking Collar
CONNECT TO VALVE INLET
3
Attach the COLD water supply connector to the
COLD water valve inlet (color BLUE). Make sure
the washer is inside the connector before tightening.
TIGHTEN CONNECTOR
4
Tighten the connector, ensuring the threads are
aligned properly for tightest fit. Inspect for kinks or
binding of the hose.
NOTE: Do not remove the plastic cap from the HOT
water inlet for uni-coupler connections as leakage may
occur.
CONNECT DRAIN HOSE
5
Attach the drain hose to the rear of the washer.
Install the clamp on the drain hose and tighten to
prevent leakage of water.
Plastic Cap
13