Washer Connections For - GE GSLS1100 Owner's Manual & Installation Instructions

WASHER CONNECTIONS FOR STATIONARY MODEL
GSLS1100 (CONT.)
PLUG THE POWER CORD INTO A
5
GROUNDED OUTLET
Insure proper ground
exists before use
RUN THE WASHER THROUGH A
6
COMPLETE CYCLE
Check for water leaks and proper operation.
ALCOVE OR CLOSET INSTALLATION
If your washer is approved for installation in an
alcove or closet, there will be a label on the back of
the machine describing requirements.
• Minimum clearances between washer and adjacent
walls or other surfaces are: 0" either side, 2" front,
3" rear.
• Minimum vertical space from floor to overhead
shelves, cabinets, ceilings, etc. is 96" .
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches open
area for washer only, or if the closet contains both
a washer and dryer, doors must contain at least 120
square inches of open area equally distributed.
NOTE: The clearances stated on this label are
minimums. Consideration must be given to
providing adequate clearances for installation
and servicing.
12
Installation Instructions
REMOVE THE PROTECTIVE FILM
7
COVERING THE CONTROL PANEL
8 READ THE REST OF THIS
OWNER'S MANUAL
It contains valuable and helpful information that will
save you time and money.
NOTE: If your washer does not operate, please review
the Before You Call For Service section.
Closet door
60 sq. in.
(387.1 sq. cm)
60 sq. in.
(387.1 sq. cm)