Replace The Ink Cartridges - Rimage 2000i User Manual

Replace the Ink Cartridges

Use the following procedure to change the ink cartridges in your Rimage 2000i.
-
Important! You must use the appropriate ink cartridges in one of the configurations listed in the
Refer to page 9.
1. Lift the ink cartridge access door. The ink cartridge carriage moves to an accessible position on the carriage guide.
2. When the ink cartridge carriage stops, lift the ink cartridge latch to the open position.
3. If an ink cartridge is already installed, slide the ink cartridge out of the ink cartridge cradle.
4. Remove a new ink cartridge from the packaging.
5. Carefully remove the protective tape that covers the ink nozzles.
-
Important! Do not touch the nozzles or the copper contacts on the ink cartridges. If you touch these parts, clogs, ink
failure, and poor electrical connections are likely to occur. Do not remove the copper strips.
6. Hold the ink cartridge so that the copper strip is on the bottom, facing toward the printer.
7. Slide the ink cartridge into the cradle.
8. Push down on the ink cartridge latch until it snaps into place.
Close the ink cartridge access door. The ink cartridge status light flashes for a few seconds. When the status light stops
9.
flashing, the Rimage 2000i is ready to print.

Note: If the ink cartridge is not securely seated in the cradle, the printer will not recognize the ink cartridge. The
printer may not reset properly or you may receive an invalid ink cartridge message. If this happens:
•
Remove the ink cartridge and reinsert it. Be sure to press firmly when you reinsert it.
•
Make sure to use the appropriate ink cartridge. Acceptable cartridges are listed in the
on page 9.
•
If the problem persists, replace the ink cartridge.
10. Align the ink cartridges. Refer to
100763_M
Align the Ink Cartridges on page 18.
Maintain the Rimage 2000i
Ink Requirements
Ink Cartridge Latch
Ink Cartridge
Ink Requirements
section.
section
25