Renault velSatis Driver's Handbook Manual page 98

STARTING AND STOPPING THE ENGINE WITH HANDS-FREE RENAULT CARD
Special cases
- When the engine is running, a
vehicle door is open and the card
is outside the vehicle (for example
when the driver gets out to open
the garage door): the engine
continues to run.
- When the engine is running, the
vehicle doors closed and the card
outside the vehicle (for example
when a passenger leaves the
vehicle and the RENAULT card
remains on him): the Card not
detected message appears on the
instrument panel. The warning
light flashes on the emergency
card reader 2 and a beep sounds
when the last door closes.
- RENAULT card operation may be
affected by interference from
nearby devices, such as exterior
installations or
operating on the same frequency
as the RENAULT card.
When you leave your
vehicle, especially if you
have your
Card with you, check
that the engine is completely
switched off.
2.06
2
Hands-Free
fault
Warning light 3 and Card reader 2
flash.
equipment
RENAULT
mode operating
(continued)
3
Insert the RENAULT Card into the
Card reader 2. Depress the brake
and/or clutch pedal and then
proceed as shown in the Starting
and stopping the engine with
remote control Card section.