HP Integrity BL870C i2 Specifications page 33

QuickSpecs
Memory
DIMM installation guidelines:
1. All DIMMs must be DDR3 registered memory modules (R-DIMMs)
2.
All four DIMM slots in a memory bank must be populated. For each CPU, the memory banks are designated as follows: first bank
consists of pairs A and B, second bank consists of pairs C and D and the third bank consists of pairs E and F.
3.
Banks must be populated in sequential Alphabetic order, starting with bank A and B for CPU0, followed by banks A and B for
CPU1, etc.
4.
All four DIMMs in a memory bank must be identical. Install identical DIMMs in quads, starting with DIMM pairs A and B CPU0.
5.
DIMMs must be installed in decreasing capacity with the largest DIMMs installed in the smallest numbered DIMM slot.
HP Integrity BL870c i2 Server Blade
Standard Memory
16 GB Registered PC310600 DDR3 1333MHz ECC DIMMs (4 x 4 GB)
Memory Bus Bandwidth:4.8GT/s
Standard Memory Plus Optional Memory
Up to 768GB of DDR3 registered memory is available.
Following are memory options available from HP:
HP Memory HP BL8x0c i2 8GB (2x4GB) PC3-10600 Registered CAS 9 Memory Kit
HP BL8x0c i2 16GB (2x8GB) PC3-10600 Registered CAS 9 Memory Kit
HP BL8x0c i2 32GB (2x16GB) PC3-8500 Registered Memory Kit
NOTE: Must be installed in quads. Therefore, must install two (2) AM327 memory
modules at a time.
NOTE: DIMMs must be installed in decreasing capacity with the largest DIMMs smallest
numbered slot.
DA - 13620 Worldwide — Version 18 — December 10, 2013
HP Integrity BL870c i2 Server Blade
AM327A
AM328A
AM363A
Page 33