Response Port Pin-Outs - McAfee M3050 - Network Security Platform Installation Manual

McAfee® Network Security Platform 6.0
Management port pin-outs
The Management (Mgmt) port uses a Cat 5/Cat 5e cable.
Note:
1 Gigabit per second (Gigabit Ethernet). For Ethernet networks running at 10 or 100
Mbps, Category 5 (Cat 5) OR Cat 5e cable can be used.
Throughout this guide, cabling specifications will be mentioned as Cat 5/Cat 5e.

Response port pin-outs

The Response ports use Cat 5/Cat 5e cables.
Pin # Signal
1 DCD Input
2 RXD Input
3 TXD Output
4 DTR Output
5 GND n/a
6 DSR Input
7 RTS Output
8 CTS Input
9 RI Input
Pin # Signal
1 TxD+
2 TxD-
3 RxD+
4 These pins are terminated to ground through a 75 ohm
resistor & capacitor.
5
6 RxD-
7 These pins are terminated to ground through a 75 ohm
resistor & capacitor.
8
Category 5 Enhanced (Cat 5e) cable is required for transmission speeds up to
Pin # Signal
1 TxD+ Output
2 TxD- Output
3 RxD+ Input
Direction on Sensor
Direction on Sensor
Output
Output
Input
Input
Direction on Sensor
43
Adding a Sensor