Table of Contents
Advertisement
McAfee® Network Security Platform 6.0
Warning:
jewelry (including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals.
Warning:
connected to earth ground during normal use.
Warning:
warranty.
Warning:
rear covers are in place. Blank faceplates and cover panels prevent exposure to
hazardous voltages and currents inside the chassis, contain electromagnetic
interference (EMI) that might disrupt other equipment, and direct the flow of cooling
air through the chassis.
Warning:
circuits to telephone-network voltage (TNV) circuits. LAN ports contain SELV
circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use
RJ-45 connectors. Use caution when connecting cables.
Warning:
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the
interference at his own expense.
Working with fiber-optic ports
Warning:
optic port. Invisible radiation might be emitted from the aperture of the port when no
fiber cable is connected.
Usage restrictions
The following restrictions apply to the use and operation of a Sensor:
Before working on equipment that is connected to power lines, remove
This equipment is intended to be grounded. Ensure that the host is
Do not remove the outer shell of the Sensor. Doing so will invalidate your
Do not operate the system unless all cards, faceplates, front covers, and
To avoid electric shock, do not connect safety extra-low voltage (SELV)
This equipment has been tested and found to comply with the limits for a
Fiber-optic ports (for example, FDDI, OC-3, OC-12, OC-48, ATM, GBIC, and
100BaseFX) are considered Class 1 laser or Class 1 LED ports.
These products have been tested and found to comply with Class 1 limits of IEC
60825-1, IEC 60825-2, EN 60825-1, EN 60825-2, and 21CFR1040.
To avoid exposure to radiation, do not stare into the aperture of a fiber-
You may not remove the outer shell of the Sensor. Doing so will invalidate your
warranty.
The Sensor appliance is not a general purpose workstation.
40
Adding a Sensor
Advertisement
Table of Contents
