Unpacking The Sensor; Cable Specifications - McAfee M3050 - Network Security Platform Installation Manual

McAfee® Network Security Platform 6.0



Unpacking the Sensor

To unpack the Sensor:
1
2
3
4
5
6
7
8
Contents of the Sensor box
The following accessories are shipped in the Sensor box:







Cable Specifications

This section lists the specifications for all cables to use with McAfee
Sensors (Sensors).
McAfee prohibits the use of the Sensor appliance for anything other than operating
the Network Security Platform.
McAfee prohibits the modification or installation of any hardware or software in the
Sensor appliance that is not part of the normal operation of the Network Security
Platform.
Place the Sensor box as close to the installation site as possible.
Position the box with the text upright.
Open the top flaps of the box.
Remove the accessory box.
Verify you have received all parts. These parts are listed on the packing list and in
Contents of the Sensor box
Pull out the packing material surrounding the Sensor.
Remove the Sensor from the anti-static bag.
Save the box and packing materials for later use in case you need to move or ship the
Sensor.
One Sensor
One power cord. McAfee provides a standard, 2m NEMA 5-15p (US) power cable (3
wire). International customers must procure a country-appropriate power cable with
specific v/a ratings.
One set of rack mounting ears.
Fail-closed dongles (two for the I-1200, four for the I-1400, six for I-2700).
One printed Quick Start guide.
Release notes.
(on page 41),
below.
41
Adding a Sensor
®
Network Security