Adding A Secondary Manager Ip; Removing A Secondary Manager Ip - McAfee M3050 - Network Security Platform Installation Manual

McAfee® Network Security Platform 6.0
Changing Sensor's shared secret key
1
2
3
4
5
6
7
8
9

Adding a secondary Manager IP

Note that this command is used to add an IP address for a second NIC in one Manager
server; this is not a command to use to set up a Manager Disaster Recovery peer—or
Secondary—Manager.
To add a secondary Manager IP,

Removing a secondary Manager IP

To remove a secondary Manager IP , type deletemgrsecintf
In the Manager Configuration page , select
Select a Sensor.
Click Edit .
Type a new .
Shared Secret
Click Save .
On the Sensor, type deinstall.
This breaks the trust relationship with the Manager.
Type the new Sensor shared secret. (This value must match the value set for the Sensor in the
Manager interface.)
Example: set sensor sharedsecretkey
The Sensor then prompts you to enter a shared secret key value. Type the shared
secret key value at the prompt. The Sensor then prompts you to verify the value. Type
the value again.
The shared secret key value must be between 8 and 25 characters of
Note:
ASCII text. The shared secret key value is case-sensitive. Example:
IPSkey123
Type exit.
On the Sensor, type set manager secondary ip <A.B.C.D.>
Specify a 32-bit address written as four eight-bit numbers separated by periods,
where A,B,C or D represents an eight-bit number between 0-255.
Example: set manager secondary ip 192.168.3.19
Or
Type set manager secondary ip <A:B:C:D:E:F:G:H>
where <A:B:C:D:E:F:G:H> is a 128-bit address written as octet (eight groups) of
four hexadecimal numbers, separated by colons. Each group ( A,B,C,D etc ) is a
group of hexadecimal numbers between 0000-FFFF.
Example: set manager secondary ip
2001:0db8:8a2e:0000:0000:0000:0000:0111
If one or more four-digit group(s) is 0000, the zeros may be omitted and replaced with
two colons (::).
Example: set manager secondary ip 2001:0db8:8a2e::0111
Device List >Device List >Devices .
51
Adding a Sensor