Foxconn Z68A-S Series User Manual page 35

Chipset Performance Tuning
Advanced
Memory Multiplier Configuration
Memory Multiplier
Memory Timing Configuration
CAS# Latency(tCL)
Row Precharge Time(tRP)
RAS# to CAS# Delay(tRCD)
RAS# Active Time(tRAS)
Write Recovery Time(tWR)
Row Refresh Cycle Time(tRFC)
Write to Read Delay(tWTR)
Active to Active Delay(tRRD)
Read CAS# Precharege(tRTP)
Four Active Window Delay(tFAW)
Intel Graphics Configuration
Graphics Core Ratio Limit
Graphics Voltage(1/10000)
► Memory Multiplier
This item is used to adjust the memory Clock Ratio. The available settimgs are: [Auto], [10.67 .],
[13.33], [16], [18.67], [21.33].
► CAS# Latency (tCL)
The number of memory clocks it takes a DRAM to return data after the read CAS_L is assert-
ed depends on the memory clock frequency. The value that BIOS programs into the memory
controller is a function of the target clock frequency. The target clock frequency is determined
from the supported CAS latencies at given clock frequencies of each DIMM.
► Row Precharge Time (tRP)
This item allows you to select the row precharge time (in clock cycles).
► RAS# to CAS# Delay (tRCD)
This item allows you to select a delay time (in clock cycles) between the CAS# and RAS#
strobe signals.
► RAS# Active Time (tRAS)
This item allows you to set the minimum RAS# active time (in clock cycles).
► Write Recovery Time (tWR)
This item allows you to select the write recovery time (in clock cycles).
► Row Refresh Cycle Time (tRFC)
Refresh to Refresh or Refresh to Active command interval.
► Write to Read Delay (tWTR)
This item allows you to select a delay time (in clock cycles) between sending the last data from
a write operation to the memory and issuing a read command.
► Active-to-Active Delay (tRRD)
This item allows you to select a delay time (in clock cycles) between the RAS# and RAS#
strobe signals.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
[13.33]
9
9
9
24
10
74
5
4
5
20
22
0
Version 2.10.1208. Copyright (C) 2011 American Megatrends, Inc.
Memory Multiplier
→ ←: Select Screen
↑ ↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
28