Cisco 2960-S Hardware Installation Manual page 88

Appendix C Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
!
interface GigabitEthernet1/0/23
!
end
These choices appear:
Step 10
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Choose (2) to save the configuration to NVRAM to use it the next time the switch reboots.
Enter your selection [2]:2
Make your selection, and press Return.
The switch now runs this default configuration. If you want to change this configuration or perform other
management tasks, see the "Management Options" section on page 1-20.
Catalyst 2960-S Switch Hardware Installation Guide
C-8
OL-19732-04