Rps Led; Master Led; Port Leds And Modes - Cisco 2960-S Hardware Installation Manual

Front Panel
For information on the System LED colors during power-on self-test (POST), see the
Results" section on page

RPS LED

Note The RPS LED is not present on the Catalyst 2960S-F48FPS-L, 2960S-F48LPS-L, 2960S-F24PS-L,
2960S-F48TS-L, 2960S-F24TS-L, 2960S-F48TS-S, and 2960S-F24TS-S switches—these models do
not support RPS.
Table 1-5
Color
Off
Green
Blinking green
Amber
Blinking amber
For information about the Cisco RPS 2300, see the

Master LED

Table 1-6
Port Mode
Off
Green
Amber

Port LEDs and Modes

The port and module slots each has a port LED. As a group or individually, the LEDs show information
about the switch and about the ports.
meanings.
Table 1-7
Mode LED
STAT
DUPLX
Catalyst 2960-S Switch Hardware Installation Guide
1-12
3-1.
RPS LED
RPS Status
RPS is off or not properly connected.
RPS is connected and can provide back-up power.
RPS is connected but is unavailable. It is providing power to another device
(redundancy has been allocated to the other device).
The RPS is in standby mode or in a fault condition. See the RPS documentation.
The power supply in a switch has failed, and the RPS is providing power to the
switch (redundancy has been allocated to this device).
Master LED
Description
Switch is not the stack master.
Switch is the stack master or a standalone switch.
An error occurred when the stack was electing the stack master switch, or another type
of stack error occurred.
Table 1-7
Port Mode LEDs
Port Mode
Port status
Port duplex
"Related Publications"
lists the mode LEDs and their associated port modes and
Description
The port status. This is the default mode.
The port duplex mode: full duplex or half duplex.
The ports operate only in full-duplex mode.
Note
Chapter 1 Product Overview
"Switch POST
section.
OL-19732-04