Truvision Nvr 40 Unit Overview; Package Content; System Requirements - GE TruVision NVR 40 User Manual

Hide thumbs Also See for TruVision NVR 40:

Table of Contents

TruVision NVR 40 unit overview

The TruVision NVR 40 (model number: TVN-40) is a network video recorder, capable of

recording video from up to 12 or 24 IP cameras (depending on the specific model).

For a full list of supported devices, refer to the IP camera compatibility list published

by GE Security.

TruVision NVR 40 storage unit is typically equipped as follows:

• One processor motherboard, with associated memory and one 2.5'' system disk.

• Two or four SATA disks for storage (1 TB each)

• One extension module:

• RS-422/RS-485 serial communication and digital I/O

Note: If you are using the device within a GE-NAV environment, go to the following

site to get the latest version of the software:

http://www.gesecurity.com/portal/site/GESecurity/menuitem.11620ebca5cc0a06574

efe10140041ca/?vgnextoid=d0b56e992c81e110VgnVCM100000592d7003RCRD

If you are using the VisioWave/UltraView CCS or VSC software solution, refer to the

appropriate CCS or VSC user manuals.

The TruVision NVR 40 package consists of the following:

• One TruVision NVR 40 unit

• One box with handles and screws

• Two power cords (one for use in EU and the other one is North America)

• One CD with TruVision NVR 40 user manuals

• One CD with GE-NAV 3.0 application software

• One quick start guide

The TruVision NVR 40 is the storage part of an IP video security system, which

includes:

• One Video security application software:

• GE-NAV 3.0 (or later)

• VSC 4.2.1 (or later)

• SDK-based application

• Storage device:

• TruVision NVR 40

• Video acquisition devices:

TruVision NVR 40 User Manual

Table of Contents