GE TruVision NVR 40 User Manual page 10

TruVision NVR 40 unit overview
Physical description
The TruVision NVR 40 unit is a 2U high enclosure for 19' rack mounting.
TruVision NVR 40 front panel
Figure 2: TruVision NVR 40 front panel
The TruVision NVR 40 unit has all its connectors on the front panel. All functions are
thus accessible via the front panel. This includes all interface modules, start button,
and all the connectors. For an exhaustive list of connectors, see Figure 7 on page 13
and section "Front panel connectors" on page 13.
There are also three LEDs to monitor the status of the main functions of the unit. See
section Figure 10 on page 15 for more LED details.
The unit has one handle on each side of the front panel to facilitate operations. These
handles need to be installed. See section "Installing handles" on page 11.
These two mounting handles on each side of the unit also make it possible to rack-
mount the chassis. See section "Rack-mounting the unit" on page 12.
TruVision NVR 40 rear panel
The rear panel of the TruVision NVR 40 only contains the fans and has no connectors.
This design is user-friendly, because equipment is rack-mounted and therefore
difficult to reach from the rear panel.
Moreover, the cooling fans can directly pump air up through the rear panel that is
covered by protective foam and expel the air via the front panel.
Figure 3: TruVision NVR 40 rear panel
See "Replacing fans" on page 29 for more information on replacing fans.
8 TruVision NVR 40 User Manual