Basic Setup - GE TruVision NVR 40 User Manual

Connecting the TruVision NVR 40
Figure 8: The Interface module connector and pin position
The detailed specifications for the module's pins are shown in Table 1.
Table 1: Module pin description
Serial + I/O 485IO-UM-1
Signal
VCC5V
N/C
GND
RXD1 +
RXD1 -
TXD1 +
TXD1 -
GND
GPI2I
GPI22
GPI23
GPI24
GPO21
GPO22
Note: For GE-NAV, only the four alarm inputs are configurable. While for VSC and
VisioWave, four alarm inputs, two outputs, and one RS-422/RS-485 are configurable.

Basic setup

To start the TruVision NVR 40 unit and connect to the network, follow this procedure:
1. Attach the power cord to the unit. See Figure 9, item 1
2. Attach the Ethernet cable to the Ethernet port. See Figure 9, item 2.
3. Press the power button on the front panel, to turn on the unit. See Figure 7.
4. The topmost LED on the front panel indicates whether AC mains power is present,
constant green indicates when the power is on. See Figure 10 on page 15.
5. You are now ready to configure the TruVision NVR 40 through its Web server
using a host computer. See Figure 11 on page 17.
14
Pin
14
13
12
11
10
9
8
7
6
5
4
3
2
1
TruVision NVR 40 User Manual