Preset Equalizer Curve Select; Audio Control; Manual Equalizer Control; Dual Zone System - Kenwood KDC-X8019BT Instruction Manual

5
Make a setting
Turn the [VOL] knob to select a setting value,
and then press the [VOL] knob.
6
Exit Audio Control mode
Press the [MENU] button for at least 1 second.
⁄
• When "iPod" is selected in the section <Preset Equalizer
curve Select> (page 36), Manual Equalizer Control is
disabled.
• You can select for each source.

Dual Zone System

Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
Display Overview
"2 Zone" Sets the Dual Zone System.
"OFF"/ "ON"
"2 Zone Rear Volume"* Adjust the volume of Rear channel.
"0" — "35"
"2 Zone Select"* Specifies the destination of sub source sound
when the Dual Zone function is turned on.
"Rear"/ "Front"
* The Dual Zone System is set to "ON".
1
Select the source
Pressing the [SRC] button repeatedly switches
source.
Select a source other than "STANDBY".
✍ SRC Select mode 2: Press the [SRC] button and
then turn the [VOL] knob. To determine the
selected source, press the [VOL] knob.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Turn the [VOL] knob and press it when the
desired item is displayed.
>
Select "Pro Setup"
4
Select the item you want to set
Turn the [VOL] knob and press it when the
desired item is displayed.
5
Exit Audio Control mode
Press the [MENU] button for at least 1 second.
( : Factory setting)
"2 Zone Control".
⁄
• Select Main source by [SRC] button.
• Adjust the volume of Front channel by [VOL] knob.
• The Audio Control has no effect on sub source.
• There are following limitations when Dual Zone System
is enabled.
- There is no output from the subwoofer.
- "Fader", "Subwoofer Level" of <Audio Control> (page 35)
and DSP function are not available.
• The Bluetooth audio source can be set exclusively to the
front speaker. Set "2Zone Select" to "Rear".
37
English |