Removing A Flexstack Cable - Cisco Catalyst 2960X-48FPD-L Hardware Installation Manual

Removing a FlexStack Cable

Procedure
Step 1 Remove the dust covers from the FlexStack cables, and store them for future use.
Step 2 Insert one end of the FlexStack cable into the stack port of the first switch. Insert the other end of the cable
into the stack port on the other switch. Make sure that you insert the cables in completely until you feel them
snap into place.
Note
Step 3 Replace the dust covers when you remove the FlexStack cables from the connectors.
Caution
Removing a FlexStack Cable
Procedure
Step 1 To remove a FlexStack cable, grasp the tab on the cable connector and gently pull straight out.
Step 2
When you remove the FlexStack cables from the connectors, replace the dust covers to protect them from
dust.
Caution
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
42
When you connect the FlexStack cable to the STACK 1 port, the tab should be above the connector.
When you connect the FlexStack cable to the STACK 2 port, the tab should be below the connector.
Removing and installing the FlexStack cable can shorten its useful life. Do not remove and insert
the cable more often than is absolutely necessary.
Removing and installing the FlexStack cable can shorten its useful life. Do not remove and insert
the cable more often than is absolutely necessary.
Switch Installation
OL-28309-02