Attaching The Rps Connector Cover - Cisco Catalyst 2960X-48FPD-L Hardware Installation Manual

Switch Installation

Attaching the RPS Connector Cover

This section only applies to the switches that have an RPS port.
If an RPS is not connected to the switch, install an RPS connector cover on the back of the switch. Statement
Warning
265
Before You Begin
Note The Catalyst 2960X-24PSQ-L switches do not have an RPS connector and a cover is not needed.
Procedure
If you are not using an RPS with your switch, use the two Phillips pan-head screws to attach the RPS connector
cover to the back of the switch.
Figure 20: Attaching the RPS Connector Cover
1
2
OL-28309-02
Phillips pan-head screws (48-0482-01)
RPS connector cover
3 RPS connector
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
Wall-Mounting
39