Cisco Catalyst 3850 Hardware Installation Manual page 109

Appendix C Configuring the Switch with the CLI-Based Setup Program
Figure C-1
Connect a USB cable to the PC USB port. Connect the other end of the cable to the switch mini-B
Step 2
(5-pin-connector) USB console port. See
Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC
Step 3
application such as HyperTerminal or ProcommPlus, makes communication between the switch and
your PC or terminal possible.
Step 4 Configure the baud rate and character format of the PC or terminal to match the console port default
characteristics:
• 9600 baud
• 8 data bits
1 stop bit
•
No parity
•
None (flow control)
•
Connect power to the switch as described in
Step 5
The PC or terminal displays the bootloader sequence. Press Enter to display the setup prompt. Follow
Step 6
the steps in the
OL-26779-02
Connecting the USB Console Cable to the Catalyst 3850 Switch
Figure
"Configuring the Setup Program" section on page
C-1.
Chapter 4, "Power Supply Installation."
C-5.
Catalyst 3850 Switch Hardware Installation Guide
Accessing the CLI
C-3