Rs-232C External Control - Meridian DILA1080pHD Installation And Operation Manual

Home theater optimized
Table of Contents

Advertisement

Terminal Description (continued)

RS-232C External Control

Control of this unit via a computer is possible by connecting the computer to this unit with a RS-232C cross cable (D-sub 9
pins). The commands to control this unit and the response data format against the received commands are explained here.
For details, please consult your authorized dealer.
1. Communication Specifications
Communication specification for this unit are as follows:
Baud Rate
Data Length
Parity
Stop Bit
Flow Control
2. Command Format
2-1. Command data format
When sending a control command to this unit, use the following data format:
Header
Header
ID
SP
CR
2-2. Response data format
Upon executing a control command it has received, this unit sends back the following response data to the com-
puter:
Header
Header
ID
SP
Normal Termination Status : 0 (30h)
CR
2-3. Parameters used for the data format
The following 3 types of parameters are used for command and response data:
1 Numeric value 2 ON/OFF 3 Special parameters
Each parameter is as follows:
1 Numeric value
A 2-byte hexadecimal value (sign included) is represented by a set of 4-digit (4-byte) characters.
Assignable range: 8000H to 7FFFH
2 ON/OFF
Shows the status (ON or OFF) of the unit, such as POWER and HIDE.
Character
0
1
36
9600/19200 bps
8 bit
None
1 bit
None
[
ID
Command
SP
SP
: Designates the head of data and the data type.
! (21h): Assigns command to the projector
? (3Fh): Query to the projector (Asking command)
:1: Identification number of the projector (Factory setting is 1)
: Designates the delimiter for ID, Command and Parameter. (20h)
: Designates the terminal of the data. (0Dh)
*[ ] is not necessary for Asking command.
ID
SP
Normal Termination Status
: Designates the head of the data.
@ (40h): Fetches data from the projector
: 1: Identification number of the projector (Factory setting is 1)
: Designates the delimiter for ID, Command and Parameter. (20h)
: Designates the terminal of the data. (0Dh)
Hex
Meaning
30
OFF
31
ON
[
Parameter
CR
[
SP
Parameter
[
CR

Advertisement

Table of Contents
loading

Table of Contents