Table of Contents
Advertisement
Basic Operation Procedures
If setting for this unit is not completed, please refer to "Adjustments and Settings Using Menus"( Page 22) upon turning on the
power and perform the required setting accordingly. Once the basic setting is completed, this unit can be used by simply
performing the following operation procedures.
ON
OPERATE
OFF
FOCUS
LIGHT
TEST
MENU
EXIT
ENTER
PRESET
HIDE
'Tele'
2
'Wide'
'Near'
3
'Far'
20
1
Turning on the power
1
Insert the power plug to the power outlet.
● The main power turns on and the [STAND BY] indicator on the unit
lights up.
LAMP
Indicators on Backup Control Panel
2
Press the [OPERATE] button on this unit (or the [OPERATE
ON] button on the remote control unit) for 1 second or more
● The [OPERATE] indicator on this unit lights up and the projected im-
age slowly appears.
1-
2
LAMP
Indicators on Backup Control Panel
Notes
● Upon projection, the image may flicker for a few seconds. This is not
a malfunction.
● When the light source is turned on, the lamp will slowly become
brighter. It will take more than 1 minute for the brightness to stabilize.
2
Adjusting zoom (screen size)
To enlarge the screen size
Turn the zoom ring towards the 'Wide' side.
To reduce the screen size
Turn the zoom ring towards the 'Tele' side.
3
Adjusting focus
To focus on nearer points
Turn the focus ring towards the 'Near' side.
To focus on farther points
Turn the focus ring towards the 'Far' side.
Light on
STAND BY
TEMP
OPERATE
Light on
STAND BY
TEMP
OPERATE
Advertisement
Table of Contents
