Installing A Pen Tether - Fujitsu LIFEBOOK T902 User Manual

If at least one finger moves at least 12 mm, a rotate is considered. If one finger is stationary (moving less than 5 mm
in any direction), and the other is moving, a rotate is considered. If the fingers begin moving in the same direction,
the rotation is canceled. If the distance between the fingers changes by more than 10 mm, the rotation is canceled.

Installing a Pen Tether

To prevent dropping or losing your pen, you should attach it
to your system using the pen tether that is included with the
system.
To attach the pen tether to your Tablet PC, perform the
following steps:
Attach the end of the pen tether with the smaller loop to
1
your pen. To do so, push the end of the tether through
the hole in the pen, then thread the opposite end of the
tether through the loop.
Attach the end of the pen tether with the larger loop to
2
the attachment point on your tablet. To do so, insert the
end of the pen tether through the attachment point,
then feed the pen through the large loop in the tether.
44 - Touchpad/Active Digitizer/Touchscreen
Figure 27. Installing a Pen Tether