Table of Contents
Advertisement
Carephone 10
6.6
Smoke alarm
Your Carephone can also be completed with a wireless smoke alarm (radio unit 4). For more
information, please contact your local dealer.
6.7
Battery error / Wristband Transmitter
The alarm button automatically sends a daily test message to the Carephone. Therefore, even
without pressing the button, your Carephone permanently monitors the transmitter battery
and optionally supervises a function problem (available for radio unit 1 and 2). Afterwards,
your monitoring center receives a message about the detected failure.
When you press the Wristband Transmitter, the LED indicator will emit a steady light.
If nothing happens when you press the Wristband Transmitter, you have to activate the alarm
by pressing the ALARM button on your Carephone.
In this case, you must contact your local dealer immediately.
6.8
Miscellaneous
Your Carephone can also handle functions such as periodical test alarms, activity monitoring
and presence control.
It can also, as an option, be equipped with an IO-board for wired alarms, e.g. a pull cord. The
functions mentioned here are just a few examples of the functions your Carephone is
equipped with. For more information, please contact your local dealer.
6.9
SERVICE and STOP buttons
By default, the STOP button is the green key and the SERVICE button is the yellow key. Their
functionality can be changed through programming.
Depending on the programming of the Carephone, the function key can allow different
functions.
6.9.1
Service call
Press the function key to call a separate service.
6.9.2
Presence marking
Pressed when staff arrives. Sets the carephone in presence mode and sends a message to the
monitoring center (option).
6.9.3
Home / Away
On pressing the SERVICE button, you activate or turn off the passive alarm. An acoustical
signal is sent when the passive alarm is turned off.
Bosch Security Systems
User Manual
Functions | en
13
953.43d | v2.0 | 2009.01
Advertisement
Table of Contents
