View Log - Bosch Security System Owner's Manual

VIEW LOG ?

Description
Use this function to review events in your system at your command center. Reviewing past events
may help you identify problems. Viewing events does not require any additional equipment since
the information is displayed at your command center. Events are stored in the panel's memory in
order of occurrence and tagged with the date and time.
Using View Log:
1. Ensure your command center is at idle text.
2. Press [9] and then [9] again and then [ENT].
3. VIEW LOG ? displays. Press [ENT].
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this
function. Press the [MENU] key to enter the Command Menu, then press [NEXT] repeatedly
until you reach the VIEW LOG ? prompt. Press [ENT].
4. ENTER START DATE displays.
• To view part of the log, enter the date (month and day, MMDD) at which you wish to
start the review. Press [ENT].
• To view the entire log from the newest event, press [ENT] without entering a start date.
The date and time of the event will display. Press [NEXT] to view the description of the
prior event, or press [PREV] to view the description of the prior event. Press [PREV]
again to view the date and time of the previous event.
• Continue to press [PREV] to view event descriptions and the date and time of each
event.
Note: When using the [NEXT] key to view the log, the date and time of the event are displayed first,
followed by the description of the event. An event description may take up 2 displays.
5. Continue pressing [NEXT] to view the rest of the log. When you reach the end of the log, END
OF LOG displays.
6. Press [ESC] to return to idle text.