Bosch Security System Owner's Manual page 29

CHG RELAYS?
Description
Your security company programs relays for automatic control and/or control from your
command center of devices such as premises lighting or entry gates. Contact them for further
information regarding the use of relays in your security system.
Using COMMAND 54:
1. Ensure your command center is at idle text.
2. Press the [COMMAND] bar. The display shows SYSTEM COMMAND.
3. Press the [5] key, then press the [4] key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the [MENU] key to enter the Command Menu, then press [NEXT] repeatedly until you
reach the CHG RELAYS ? prompt. Press [ENT].
4. When ENTER RELAY displays enter the relay number of the relay you wish to operate, and
press [ENT].
5. If the relay is currently off, the display shows RELAY X ON ?. If you want to turn this relay
turned on, press [ENT]. If you want it to remain off, press [NEXT]. The display shows RELAY X
IS OFF. Press [ENT].
• If the relay is currently on, the display shows RELAY X OFF ?. If you want to turn this
relay turned off, press [ENT]. If you want it to remain on, press [NEXT]. The display
shows RELAY X IS ON. Press [ENT].
6. The display shows ENTER RELAY. If you wish to change another relay, enter its number and
press [ENT].
7. You can return to idle text by pressing [ESC].
54